AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |
Back to Blog
Artistic licences DMX workshop prorgram4/12/2024 ![]() ![]() The first network interface has the address 2.0.0.1. My two ADJ Flash Kling Batten are configured as 40x4 RGB Matrix in QLC+ universe 1 and 2. Well, I found a work around by adding a network interface in another address range. I despair of not being able to configure these fixtures to give them a unique identity. I would be so happy if these two RGB Matrix could be displayed on each ADJ batten. ![]() I observed if I configure the output of the Artnet plugin to map DMX universes 1 and 2 to the Artnet universe 0, two RGB matrix effect setted to two RGB panel are superimposed on the identical display of the two Flash Kling Batten. But the Batten do not respond to the Artnet 1,2,3 universes. To configure a second RGB Panel (480 channels), I have to add a DMX universe in QLC+. When I connect RJ-45 to second ADJ Flash Kling Batten, it copies the RGB Matrix effect like the first fixture. Thanks for Wireshark, but I would need more than luck to get anything out of him.ĭMX-Workshop also has a packet dessicator which shows me the traffic between the PC and the broadcast address.īy configuring QLC+ with an RGB Panel of 40 columns and 4 rows in universe 0, I quickly obtain nice RGB Matrix effects with the Artnet output on universe 0. (for info: even the small Showtec NET 2/3 node has an embedded website to configure it, in addition to the lcd screen and keypad) Yet the ping radar menu shows an additional address x.x.x.255, but this address does not respond as a website. Looks like the ADJ is not an Artnet node. The fixture is not detected by DMX-Workshop. I tried again with another PC and a straight cable between this PC and a single Flash Kling Batten. Is there another way to configure qlc+ to get a 40x8 or 80x4 individual pixel matrix with my two Flash Kling Batten ? Has anyone ever experienced setting up this kind of "native art-net" led panel? I really need to change the universe of one of the ADJ Flash Kling Batten so that QLC+ can control them separately (480 channels per panel) I downloaded the DMX-Workshop but it does not identify the ADJ panels, while it recognizes the Showtec NET 2/3 hub The bad news is that these panels react the same way, replicating the same matrix pattern.ĪDJ Flash Kling Batten's 6-page manual states that you must use Artist License's DMX-Workshop tool to configure the network of these fixtures ![]() The good news is that these panels also work with my configuration in universe 1, in the 2.0.0.0/8 network, daisy chained with the Showtec NET 2/3 I find very little information on the net about these discontinued led bars I bought two second-hand ADJ Flash Kling Batten (40 x 4 led panel) which have the particularity of being directly connected by RJ-45 ArtNet cable and not having a configuration panel with keypad. My setup runs with an ArtNet hub (Showtec NET 2/3 Pocket) with two DMX universes 2 and 3. I am relatively newbee using this wonderful QLC+ software and I need your help. ![]()
0 Comments
Read More
Leave a Reply. |